You are here: Home 
High Security Products EPEG V2
High Security Products EPEG V2
|
EPEG V2 | |
Item Code : JS233 Title : EPEG V2 BASE-KEYSWITCH MODEL Application : Electronic Protection of External Grilles PDF Specification Sheet: Download Now OVERVIEW Businesses and increasing numbers of homeowners install external steel window grilles in order to discourage break-ins however; determined criminals continue to employ a number of creative methods of attack in order to gain entry. EPEG was developed to address one particular form of attack when a major international Bank reported high level security incursions at a number of High Street branches. At night, or in the early hours of the morning, criminals target a window that is out of sight and spend many hours cutting through the bars with a hacksaw – sometimes over a period of several days so not to arouse suspicion. The bars are then put back in place and disguised in a manner to hide any trace that they have been tampered with. During normal business hours the criminals remove the bars, climb through the window and conduct a raid in the knowledge that cash will be easily accessible. Resorting to intimidation and violence, offenders are able to execute a rapid assault and vacate the premises before police are able attend. Before the branch is opened to customers, an ‘opening-up’ procedure is carried out that includes a visual examination of grilles. In many cases however, these may be impossible to inspect thoroughly due to inaccessibility. This model of EPEG reports grille integrity as a standalone visual early-warning system for staff. Although designed to detect a specific type of attack, EPEG will also recognise tampering or attempts to forcibly remove the grille in any manner. Each kit can protect most metal grilles up to 1.2 by 1.2 metre in size – regardless of material gauge. The EPEG kit has two principle components: an internally fitted Analyser and an external weatherproof sensor (our Item Code JS232) fitted to the grille. Flexible conduit (3 metres) and all associated fittings are supplied as standard. EPEG may be powered from any 12 volt DC supply or from the supplied 9 volt battery. The analyser will report a low battery condition which may be replaced during routine maintenance. Three open collector type outputs for Alarm, Tamper & Battery Low status are also provided. Installation is simple and no set-up or adjustment is required. JS233 - ELECTRICAL & MECHANICAL DATA Power requirement: 12 Volts DC or PP3 9 Volt Lithium Battery Operating Voltage Range: 10.5 – 15.0 Volts DC (applied to the DC terminals) Battery life: Approx. 12 months (governed by the number of alarm activations) Peak Quiescent Current: 120 uA Maximum Current consumption: 45 mA Outputs: Alarm, Tamper & Low Battery - Open-collector type; normally closed; Maximum current sink = 50 mA per circuit; Maximum sink voltage = 15 Volts DC. Cable entries: 2 off 20mm sleeved grommets Construction: Black ABS plastic Dimensions (mm): 153 (H) x 76 (W) x 52 (D) JS232 – ELECTRICAL & MECHANICAL DATA Power requirement: Derived from Analyser Cable entry: 1 off 16mm sleeved grommet Construction: Black ABS plastic sealed to IP65 Dimensions (mm): 61 (L) x 18 (D) x 32 (W) Installation Note: The sensor must be fitted one-way up only and in a horizontal position |
||
Downloads
| Technical PDFs |
